1995 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor

  1. Unplug connector from TP sensor, located on throttle body. Turn ignition on. Measure voltage between Yellow/Blue (positive) and Green/Blue (negative) wire terminals. If voltage is not about 5 volts, check wiring between TP sensor and ECM. If wiring is okay, replace ECM.
  2. If voltage is about 5 volts, turn ignition off. Reconnect wire harness to throttle angle sensor. Connect test harness between ECM and vehicle wire harness. Turn ignition on. Measure voltage between test harness terminals D11 and D22. Voltage should be about .5 volt with throttle valve at full-closed position, and about 4.5 volts with throttle valve at full-open position. As throttle opens, voltage should increase smoothly from .5 volt to 4.5 volts.
  3. On Integra with automatic transmission, if voltage is not as specified, disconnect Transmission Control Module (TCM) and repeat step 2). If voltage is now as specified, replace TCM.
  4. On all models, if voltage is not as specified, check for short or open in Red/Black wire between ECM and TP sensor. Repair as necessary. If wire is okay, replace TP sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.