Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES
| Component | Component Location |
|---|---|
| ABS Pressure Switch | On ABS modulator unit. |
| A/C Pressure Switch | In refrigerant pipe, between receiver-drier & condenser. |
| A/T Gear Position Switch | Below center console, at base of shift lever. |
| Back-Up Lamp Switch | On left front corner of transaxle. |
| Brake Fluid Level Switch | On bottom of brake fluid reservoir cap. See Figure . |
| Brakelamp Switch | On bracket, above brake pedal. |
| Clutch Interlock Switch (M/T) | On bracket, above clutch pedal. |
| Clutch Switch (M/T) | On bracket, above clutch pedal. |
| Driver's Seat Belt Switch | In driver's seat belt buckle. |
| Engine Coolant Temperature Switch | Lower right rear of engine, on thermostat housing. |
| Engine Oil Pressure Switch | Near oil filter. |
| Parking Brake Switch | On base of parking brake lever. |
| Parking Pin Switch | Below left side of front console. |
| Power Steering Pressure (PSP) Switch (1.8L) | On left side of engine compartment, on power steering line. See Figure . |
| Power Steering Pressure (PSP) Switch (1.8L VTEC) | On left side of engine compartment, on power steering line. See Figure . |
| VTEC Pressure Switch (1.8L VTEC) | On right side rear of engine. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
