Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra GS-R, 4D SedanFACTORY OEM SERVICE PROCEDURE
Adjusting Ignition Timing
- Check ignition timing. See CHECKING IGNITION TIMINGΒ . If Red mark and pointer are not aligned, adjust timing. See IGNITION TIMINGΒ . Red mark on crankshaft pulley should align with pointer. See Figure .
- If Red mark and pointer are not aligned, adjust base ignition timing by turning distributor. See IGNITION TIMINGΒ . Remove short connector from ignition timing adjusting connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
