Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Relieving System Pressure
Remove bleed screw cap from maintenance bleed screw on modulator. See Fig 1 . Attach wrench to maintenance bleed screw. Connect a rubber tube of appropriate diameter to maintenance bleed screw, and place other end in a suitable container. Hold rubber tube, and slowly loosen maintenance bleed screw 1/8-1/4 turn to drain brake fluid from modulator. After fluid stops flowing, loosen bleed screw further to relieve pressure completely. Tighten bleed screw.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.