Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra GS-R, 2D CoupeFACTORY OEM SERVICE PROCEDURE
Bleeding Brake System: Bleeding
- Fill brake fluid reservoir to MAX (upper) level with new brake fluid. Connect a rubber tube of appropriate diameter to maintenance bleed screw, and place other end in a suitable container. Loosen maintenance bleed screw. Start engine to activate ABS pump motor.
- Tighten bleed screw when fluid begins to flow from bleed screw. Stop engine when ABS pump motor stops. If ABS indicator light illuminates and ABS pump motor stops, start engine and repeat procedure. Ensure brake fluid level is at MAX (upper) level of reservoir.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.