Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)FACTORY OEM SERVICE PROCEDURE
Spark Plug: Service and Repair
WARNING: Perform this on an engine that has cooled to prevent burns.
1. Remove the spark plug wires covering the spark plugs.
2. With an appropriate socket, remove the spark plugs.
3. Before installing spark plugs, set the gap to 1.2-1.3 mm (0.047-0.051 in).
4. Install spark plugs, torque to 20 Nm (13 ft lb)
1. Remove the spark plug wires covering the spark plugs.
2. With an appropriate socket, remove the spark plugs.
3. Before installing spark plugs, set the gap to 1.2-1.3 mm (0.047-0.051 in).
4. Install spark plugs, torque to 20 Nm (13 ft lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.