1995 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)FACTORY OEM SERVICE PROCEDURE

Engine Control Module: Service and Repair

ECM Location:

Factory service manual diagram





WARNING: To prevent Electrostatic Discharge from damaging the Engine Control Module (ECM), touch a grounded area before handling the ECM.

1. Turn off ignition switch.
2. Disconnect negative battery cable.

NOTE: Disconnecting the negative battery cable also cancels the anti-theft/radio presets and clock settings. Make note of the presets (and anti-theft radio codes if so equipped) before removing the fuse.


3. Remove door sill molding and kick panel.
4. Pull away carpet back to expose the ECM cover.
5. Remove ECM cover bolts.
6. Remove the four ECM mounting bolts.
6. Remove ECM from vehicle.
7. Reverse procedure to install. Insure all connections to ECM are tight and secure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.