Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)FACTORY OEM SERVICE PROCEDURE
Component Locations
To see where a component or connector is located on the car, look up its photo number in the Component Location section. The photo will also tell you the color of the connector, and how many cavities it has.
Component Locations:
If there is no photo number below or beside a connector, ground, or terminal number, look up that connector, ground, or terminal number in the appropriate Connector Identification Chart. The chart will tell you the color of a connector, how many cavities it has, where it's located, and what component or harness it connects to. Along with this chart you'll find an image giving illustration of the related harness.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.