Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura 2.5TLFACTORY OEM SERVICE PROCEDURE
Code P1297 - Electrical Load Detector (Eld)
- Connect and operate scan tester, following manufacturer's instructions. Clear codes. Start engine. Turn headlights on. Retrieve codes. If Code 1297 appears, go to next step. If Code P1297 does not appear, problem is intermittent. Inspect for poor connections or loose wires associated with ELD sensor, then repair as necessary.
- Turn ignition and headlights off. Unplug ELD connector. Turn ignition on. Measure voltage between Black/Yellow wire at ELD harness connector and ground. If battery voltage exists, go to next step. If battery voltage does not exist, repair open Black/Yellow wire between ELD connector and fuse panel.
- Measure voltage between ELD harness connector terminal No. 2 (Green/Red wire) and ground. If voltage is not about 5 volts, go to next step. If voltage is about 5 volts, temporarily substitute known good ELD, then retest system.
- Turn ignition off. Unplug 22-pin connector from ECM. Test for continuity between harness connector pin No. 16 (Green/Red wire) and ground. If continuity exists, repair shorted Green/Red wire. If continuity does not exist, temporarily substitute known good ECM, then retest system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
