1995 Acura 2.5TLFACTORY OEM SERVICE PROCEDURE

Code P0118 - Engine Coolant Temperature Sensor High

  1. Connect and operate scan tester, following manufacturer's instructions. Turn ignition on. Read engine coolant temperature. If indicated temperature is less than -22°F (-30°C), go to next step. If indicated intake air temperature is not less than -22°F (-30°C), problem is intermittent. Inspect for poor connections or loose wires at ECT sensor and ECM, then repair as necessary.
  2. Turn ignition off. Unplug ECT sensor. Connect Green/White and Red/White wires together at ECT sensor harness connector. Turn ignition on. Read intake air temperature. If indicated intake air temperature is less than -22°F (-30°C), go to next step. If indicated intake air temperature is not less than -22°F (-30°C), temporarily substitute known good ECT sensor, then retest system.
  3. Turn ignition off. Connect ECM harness connector terminals D7 (Red/White wire) and D11 (Green/White wire). Turn ignition on. Read intake air temperature. If indicated intake air temperature is not less than -22°F (-30°C), repair open Red/White or Green/White wire. If indicated intake air temperature is less than -22°F (-30°C), temporarily substitute known good ECM, then retest system.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.