Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura 2.5TLFACTORY OEM SERVICE PROCEDURE
Ignition Coil Power Source
- Disconnect ignition coil primary leads. Turn ignition on. Measure voltage between ground and Black/Yellow wire of ignition coil wiring harness. See Figure.
- Battery voltage should exist. If battery voltage does not exist, inspect for open in Black/Yellow wire between ignition coil and ignition switch. If wire is okay, go to IGNITOR INPUT TEST procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.