Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Acura 2.5TLFACTORY OEM SERVICE PROCEDURE
Fuel Tank: Replacement
WARNING:
Do not smoke while working on fuel system. Keep open flame away from your work area.
- Relieve the fuel pressure (see FUEL SYSTEM PRESSURE RELEASEΒ ).
- Jack up the vehicle, and support it with jackstands.
- Remove the drain bolt, and drain the fuel into an approved container.
- Remove the fuel pipe cover and fuel hose protector.
- Disconnect the hoses. Slide back the clamps, then twist hoses as you pull, to avoid damaging them.
- Place a jack, or other support, under the tank.
- Remove the strap nuts, and let the straps fall free.
- Disconnect the 2P and 3P connectors.
- Remove the fuel tank. NOTE: The tank may stick on the undercoat applied to its mount. To remove, carefully pry it off the mount.
- Install the drain bolt with a new washer, then coat the drain bolt with Noxrust 124B. Allow the Noxrust to dry for 20 minutes.
- Install the remaining parts in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
