Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Acura Integra (GS-R) L4-1797cc 1.8L DOHC (VTEC)FACTORY OEM SERVICE PROCEDURE
Shift Position Console Switch
Fig. 19 Shift Position Console Switch:
1. Remove front console and center instrument panel. Disconnect console switch connector.
2. Check for continuity between terminals in each switch position as shown in Fig. 19.
3. Move lever back and forth not touching push knob at each position and check continuity within range of freeplay of shift lever. If no continuity exists within freeplay range, adjust installation position of console switch.
4. Shift to P position and loosen two bolts retaining switch. Slide switch in direction of D position or until there is continuity between terminals 1 and 7.
5. Recheck for continuity between each of the terminals. If adjustment is not possible, check for damage in shift detent. If there is damage, replace console switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
