Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

Check for battery voltage between ECM terminal D1 and ground. If battery voltage is not present, check fuse No. 15. (located in underdash fuse block). If fuse is okay, check for an open in Yellow/Blue wire between fuse block and ECM.
Turn ignition on. Check for battery voltage between ground and ECM terminals A25 and C1. If battery voltage is not present, check fuse No. 5 (located in underdash fuse block). If fuse is okay, check for an open in Yellow/Black wire between main relay and ECM terminals A25 and B1, defective main relay, or defective ignition switch.
Connect DVOM between ECM terminal C11 and ground. Hold ignition switch in START position. Battery voltage should be present between ECM terminal C11 and ground ONLY when ignition switch is in the START position.
If battery voltage is not present, check fuse No. 14 (located in underdash fuse block). If fuse is okay, check for an open in Blue/White wire between fuse No. 18 and terminal C11 of ECM, or check for a defective ignition switch.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Power Circuits