Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different car, the 1994 Acura Integra. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Ball Joint Castle Nut | 40 (54) | ||
| Damper Fork Pinch Bolt | 47 (64) | ||
| Engine Stiffener Bracket-To-Engine Bolt | 17 (23) | ||
| Engine Stiffener Bracket-To-Transaxle Bolt | 42 (57) | ||
| Flywheel-To-Crankshaft Bolt (1) | 76 (103) | ||
| Intermediate Shaft Support Bolt | 29 (39) | ||
| Pressure Plate-To-Flywheel Bolt (1) | 19 (26) | ||
| Radius Arm Nut | 32 (43) | ||
| Rear Mount-To-Transaxle Bolt | 43 (58) | ||
| Release Fork Bolt | 22 (29) | ||
| Starter Motor Bolt | 32 (43) | ||
| Transaxle Mounting Bolt/Nut (Firewall Side) | 54 (73) | ||
| Transaxle Mounting Bolt/Nut (Front) | 47 (64) | ||
| Transaxle-To-Engine Mounting Bolt | 42 (57) | ||
| Transaxle Torque Rod Bolt | 16 (22) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.