1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 1992 Acura Integra and 1991 Acura Integra. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Ball Joint Castle Nut 40 (54)
Damper Fork Pinch Bolt 47 (64)
Distributor Mounting Bolt 16 (22)
Engine Stiffener Bracket-To-Engine Bolt 17 (23)
Engine Stiffener Bracket-To-Transaxle Bolt 42 (57)
Flywheel-To-Crankshaft Bolt (1) 76 (103)
Intermediate Shaft Support Bolt 29 (39)
Pressure Plate-To-Flywheel Bolt (1) 19 (26)
Radius Arm Nut 32 (43)
Rear Mount-To-Transaxle Bolt 43 (58)
Release Fork-To-Transaxle Bolt 21 (28)
Spindle Nut 134 (182)
Starter Motor Bolt 32 (43)
Transaxle Mounting Bolt/Nut (Firewall Side) 54 (73)
Transaxle Mounting Bolt/Nut (Front) 47 (64)
Transaxle-To-Engine Mounting Bolt 42 (57)
Transaxle Torque Rod Bolt 16 (22)
Wheel Lug Nut 80 (108)
(1) Tighten bolts in a crisscross pattern.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.