1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Ignitor Input Test (Vigor)

  1. Turn ignition off. Disconnect 4-pin connector from ignitor. Using ohmmeter, check for continuity between Black wire and body ground. See Fig 1. If continuity does not exist, check for open wire or bad ground connection. If continuity is present, go to step 2.
  2. Turn ignition on. Using voltmeter, check for battery voltage between Black/Yellow wire and Black wire of harness. If voltage is present, go to next step. If voltage is not present, check for open in Black/Yellow wire or wiring harness connector. If wire and connector are okay, go to appropriate IGNITION COIL TEST procedure.
  3. With ignition on, ensure battery voltage exists between Blue wire and Black wire at ignitor wiring harness connector. If voltage is not present, check for open circuit in Blue wire. If circuit is okay, go to appropriate IGNITION COIL TEST procedure.
    Fig 1: Testing Ignitor Circuit (Vigor)
    G92A26195Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.