1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Starter Function Test

  1. Disconnect wiring harness connector from ignition coil. On M/T models, depress clutch pedal to floor. On all models, turn ignition switch to START position. Starter should crank.
    NOTE: On M/T models, starter will not crank unless clutch pedal is fully depressed.
  2. If starter does not crank, check battery condition. Check for loose or corroded battery cables and starter wires. Repair or replace as necessary. If starter still does not crank, unplug terminal "S" connector (Black/White wire) from starter solenoid.
  3. Connect jumper wire between positive battery terminal and solenoid terminal "S". Starter should crank. If starter does not crank, remove starter and check for internal problems. If starter cranks, check Black/White wire, fuse, starter relay, ignition switch, clutch interlock switch (M/T) or neutral safety switch (A/T). Repair or replace as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.