1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Using ABS Tester

  1. Ensure ignition is off. Block wheels, and set parking brake. Connect ABS Tester (07HAJ-SG0010B) to 6-pin inspection connector. See Figure . Ensure vehicle is on level ground and automatic transmission is in Park or manual transmission is in Neutral.
  2. Fill modulator reservoir to MAX level. Bleed high-pressure fluid from maintenance bleeder screw. See Figure . Start engine, and release parking brake. Turn ABS tester mode selector to "2" position. Depress brake pedal firmly and press START TEST button.
  3. At least 2 strong kickbacks should be felt from brake pedal. Repeat procedure in ABS tester mode selector positions "3", "4" and "5". If kickbacks are not felt, repeat step 2).
  4. Fill modulator reservoir to MAX level. Perform system function test. See ABS FUNCTION TEST  under DIAGNOSIS & TESTING.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.