Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Control Unit Input Test
- Turn ignition off. Remove dashboard lower left cover. Remove left knee bolster. Cruise control unit is located near left kick panel. Unplug cruise control unit 14-pin connector.
- Using a DVOM, perform cruise control unit input tests in Fig 1 . If all input test results are okay, inspect cruise control unit connector for damage and proper fit. If connector is okay and cruise control still malfunctions, replace cruise control unit.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.