Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Shift Control Cable
- Start engine. Shift to Reverse. Ensure transaxle engages in Reverse. With engine off, remove console. Shift gear selector into NEUTRAL position. Remove lock pin from cable adjuster. Ensure hole in adjuster is perfectly aligned with hole in shift cable. See Fig 1 .
- Two holes in end of shift cable are positioned at 90 degrees to allow cable adjustments in 1/4-turn increments. Loosen lock nut on shift cable, and adjust if necessary. See Fig 1 . Tighten lock nut. Install lock pin on adjuster.
- Lock pin should not bind as it is installed. If it binds, cable is still out of adjustment. Repeat adjustment procedure. Start engine, and check shift lever selection of all gears.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.