Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Control Unit Input Test No. 10
NOTE:
With ignition switch ON, connect the 7-P and 22-P connectors to the control unit and perform test.
CONTROL UNIT INPUT TEST NO. 10
| Wire | Test Condition | Test: Desired Result | Possible Cause,If Result is not Obtained | ||
|---|---|---|---|---|---|
| GREEN/ BLUE or (GREEN/ RED) | Driver or passenger door closed | Check for voltage to Ground should be less than 1V. (1) | Short to ground, Faulty door latch sw. or faulty ctrl unit. | ||
| GREEN/ BLUE or (GREEN/ RED) | Driver or passenger door open | Check for voltage to Ground should be approx. 5V or more. (1) | An open in wire orFaulty door latch switch. | ||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.