Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Legend Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Code 17: Vehicle Speed Sensor (VSS)
- Turn ignition off. Remove No. 15 (ACG) fuse from underdash fuse box for 10 seconds to reset ECU. Road test vehicle. While in 2nd gear, accelerate until engine speed reaches 4000 RPM, and then with throttle fully closed decelerate to 1500 RPM.
- Check ECU for fault codes. See RETRIEVING CODESΒ . If Code 17 is not present, problem is intermittent. Check for poor connections at ECU connector and VSS connector. Test drive vehicle and retest.
- If Code 17 is present, raise and support vehicle. Connect ECU Test Harness (07LAJ-PT3010A ) between ECU and ECU connector. See Figure . Place transaxle in Neutral. Turn ignition on. Slowly rotate left front wheel and measure voltage between test terminals A26 (-) and C2 (+). If voltage pulses 0-5 volts, substitute a known good ECU, and retest. If specified voltage is now present, replace original ECU.
- If voltage does not pulse 0-5 volts in step 3), repair short in Yellow/Red wire between ECU terminal C2 (+) and VSS. If wire is okay, replace VSS. If voltage still does not pulse 0-5 volts, substitute a known good ECU, and recheck. If symptom/condition goes away, replace original ECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.
