Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Legend Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Ignitor Input Test (Legend)
- Turn ignition off. Disconnect wiring harness from ignitor. Using ohmmeter, check for continuity between Black wires and ground. If continuity does not exist, check for open wire or bad ground connection.
- Turn ignition on. Using voltmeter, check for battery voltage between ground and each White wire of harness (including White wires with tracer color). See Fig 1 . If voltage is not present, check for blown fuse No. 25 or open circuit. If circuit and fuse are okay, replace ignition coil.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.