1992 Acura Legend Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Master Switch

Remove power window master switch. See WINDOW SWITCH under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals with switch in each position. If continuity is not as specified, replace switch. See Fig 1 . See appropriate POWER WINDOW MASTER SWITCH TEST table.

NOTE: The driver's switch cannot be isolated for testing. Perform SWITCH INPUTS TEST. See Figure . If inputs are normal, but driver's switch does not operate properly, replace master switch assembly.
POWER WINDOW MASTER SWITCH TEST

Position Main Switch Pin Continuity
Right Front Switch
Off On "G"-"P"-"Q"
Off "G"-"P"
Up On "C"-"P"
Off "G"-"Q"
Down On "C"-"G"; "P"-"Q"
Off "C"-"G"
Right Rear Switch
Off On "M"-"N"-"Q"
Off "M"-"N"
Up On "O"-"M"; "N"-"Q"
Off "M"-"O"
Down On "N"-"O"; "M"-"Q"
Off "N"-"O"
Left Rear Switch
Off On "D"-"E"-"Q"
Off "D"-"E"
Up On "D"-"F"
Off "E"-"Q"
Down On "E"-"F"; "D"-"Q"
Off "E"-"F"
Fig 1: Master Switch Terminal ID
G93B82546Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.