Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs (N.m) | ||
|---|---|---|---|
| Center Crossmember (Integra) | 33 (45) | ||
| Drain Plug | 30 (40) | ||
| Drive Plate-To-Crankshaft | 55 (75) | ||
| Exhaust Header Pipe | 41 (55) | ||
| Exhaust Pipe Bracket | 29 (39) | ||
| Extension Shaft Sealing Bolt | 59 (80) | ||
| Front Engine Mount Bolt | 48 (65) | ||
| Intermediate Shaft Mount Bolt | 30 (40) | ||
| Lower Plate Bolts | 29 (39) | ||
| Rear Transaxle Mount Bolt | 44 (60) | ||
| Rear Transaxle Mount Bracket | 29 (39) | ||
| Shift Cable Guide Bolt | 16 (22) | ||
| Starter-To-Housing Bolt | 33 (45) | ||
| Top Transaxle Mount Bolt | 41 (55) | ||
| Torque Converter Bolt | (1) | ||
| Transaxle Housing-To-Engine Bolt | 44-74 (60-100) | ||
| Transaxle Middle Mount-To-Engine Bolt | 28 (38) | ||
| INCH Lbs. (N.m)Β | |||
| Flywheel Inspection Cover Bolt | 106 (12) | ||
| Shift Cable Housing Bolt | 89 (10) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
