Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Lock Assembly: Installation
To install, reverse removal procedure. Tighten new shear bolts until heads twist off. Check for proper ignition switch steering lock operation.
Turn ignition switch to "1" position. Push in on steering lock retaining pin and install steering lock assembly until assembly clicks into place. Install and loosely tighten new shear bolt. Insert ignition key and check for proper steering lock operation. Tighten shear bolt until hex head twists off. To complete installation, reverse removal procedure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.