1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Rack Guide Adjustment

  1. Using Lock Nut Wrench (07916-SA50001 ), loosen rack guide screw lock nut. See Fig 1 or Fig 2 . Tighten rack guide screw until spring is compressed against guide.
  2. Loosen rack guide screw, and retighten to 36 INCH lbs. (4 N.m). Back off rack guide screw about 25 degrees. Holding rack guide screw in place, tighten lock nut to 18 ft. lbs. (24 N.m). Check steering effort. See STEERING EFFORTΒ  under TESTING.
Fig 1: Exploded View of Power Steering Gear (Integra)
G91E01105Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.