Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
O.E.M. Clutch Bearing Precautions (ACU0077AP)
Reference number: ACU0077AP
O.E.M. CLUTCH BEARING PRECAUTIONS
TECHNICAL INFORMATION TIP
INTEGRA CLUTCH RELEASE BEARING
YEAR(S): All
MANUFACTURER: Acura
MODELS: Integra
ISSUE & TIP
Be careful. The O.E. Acura Integra clutch release bearings have been slightly changed. The new bearings (P/N 22810 PC8923) may have small irregularities on the outside surface which can cause the bearing to hang up on the cross shaft if it is improperly installed. This can result in no free play, causing that new clutch you just installed to slip.
Courtesy of Import Service Magazine with thanks to:
Mike Apple
Bill Smith Foreign Car
Solana Beach, California
REFERENCE NUMBER
ACU0077AP
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
