Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| ABS Accumulator Pressure Switch | Below battery. See Figure . |
| ABS Fluid Level Switch | On bottom of brake fluid reservoir cap. See Figure . |
| A/C Dual-Pressure Switch | In refrigerant pipe between receiver-drier and condenser. |
| A/C Thermostat Switch | Behind center of dash, on right side of heater assembly. |
| Back-Up Switch | At left front corner of transaxle. |
| Brakelight Switch | On bracket, above brake pedal. |
| Clutch Interlock Switch | On bracket, above clutch pedal. |
| Clutch Switch | On bracket, above clutch pedal. |
| Coolant Temperature Switch | Lower right rear of engine, on thermostat housing. See Figure . |
| Neutral Safety Switch (A/T) | Integrated with shift lever position switch. |
| Oil Pressure Switch | At back of engine, between oil temperature sensor and oil filter. |
| Oil Temperature Switch | At back of engine, between alternator and oil pressure switch. See Figure . |
| Parking Brake Switch | At base of parking brake lever. |
| Power Steering Oil Pressure Switch | On left side of engine compartment. See Figure . |
| Seat Belt Switch | In driver's seat belt buckle. |
| Shift Lever Position Switch | Below center console, at base of shift lever. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.