1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Code 13: Atmospheric (Pa) Sensor

WARNING: This page is about a different car, the 1992 Acura Legend. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Atmospheric sensor is built into ECU. No circuit testing is required.
  1. Turn ignition off. Remove No. 15 (ACG) fuse from underdash fuse box for 10 seconds to reset ECU. Check ECU for fault codes. See RETRIEVING CODESΒ  . If Code 13 is not present, problem is intermittent. Check for poor connections at ECU connector.
  2. Test drive vehicle and check again. If Code 13 is present, substitute a known good ECU. If symptom/condition goes away, replace original ECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.