Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
IGNITOR Unit
Battery voltage is supplied through ignition switch, to ignition coil and ignitor unit. The PGM-FI control unit uses input signals from TDC/crank (or crank/CYL) sensor, throttle angle sensor, coolant sensor and MAP sensor to directly activate the ignitor. When activated, ignitor triggers ignition coil(s). On Integra and Vigor, induced voltage from ignition coil is then distributed to each spark plug by the distributor.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
