Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Automatic Transmission
- EGR lift sensor is part of EGR valve, located on top of engine. Turn ignition on. Measure voltage between terminals of Yellow/White wire (positive) and Green/White wire (negative) by backprobing EGR valve lift sensor connector. If voltage is not about 5 volts, repair open in Yellow/White or Green/White wire between ECU and EGR valve.
- Measure voltage between Yellow wire (positive) and Green/White wire (negative) by backprobing EGR valve lift sensor 4-wire connector. If voltage is about 1.2 volts, slowly apply 8 in. Hg vacuum to EGR valve. Completely release and reapply vacuum several times. Voltmeter should indicate about 4 volts with vacuum applied. If voltage is not as specified, replace EGR valve.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
