Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Coolant Temperature (TW) Sensor
TW sensor is threaded into upper front side of engine. Unplug 2-wire connector (Red/White and Green/White wires) from sensor. Resistance should be as specified in COOLANT TEMPERATURE (TW) SENSOR RESISTANCE table.
COOLANT TEMPERATURE (TW) SENSOR RESISTANCE
| Temperature - °F (°C) | (1) (Ohms) | ||
|---|---|---|---|
| -4 (-20) | 15,000-18,000 | ||
| 68 (20) | 1000-4000 | ||
| 176 (80) | 200-400 | ||
| 248 (120) | 50-150 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.