Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Idle Speed: Integra
- Start engine and operate until cooling fan comes on. Connect tachometer. Disconnect 2-wire connector from Electronic Air Control Valve (EACV). See Fig 1 .
- Check base idle speed with gear in Neutral (A/T in "N" or "P") and all accessories off, including cooling fan. Turn screw to adjust base idle speed to 550-650 RPM. See Fig 2 .
- Turn ignition off. Reconnect 2-wire EACV connector. Remove hazard fuse at battery positive terminal for 10 seconds to reset ECU. Start engine and allow to idle for one minute.
- Check idle speed with engine under load (A/C on) and under no load (A/C off). Idle speed should be 700-800 RPM. See IDLE SPEED SPECIFICATIONS table.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.