1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
A/C Compressor Bracket Bolts 17 (23)
Alternator Belt Adjustment Bolt 17 (23)
Alternator Mount Bolt 33 (45)
Camshaft Retaining Bolts (1)
Camshaft Sprocket Bolts 27 (37)
Connecting Rod Nuts (2) 23 (31)
Crankshaft Pulley Bolt 87 (118)
Cylinder Head Bolts (3) 61 (83)
Distributor Mount Bolts 16 (22)
Engine Block-To-Transaxle Housing Bolts 47 (64)
Engine Mount Bolts (4)
Exhaust Manifold Nuts 23 (31)
Exhaust Pipe Flange Nuts 40 (54)
Flexplate (A/T) 55 (75)
Flywheel Bolts (M/T) (5) 76 (103)
Intake Manifold Nuts 17 (23)
Main Bearing Cap Bolts 56 (76)
Oil Pump Bolts
6-mm Bolts (6)
8-mm Bolts 17 (23)
Power Steering Mount Bolt 17 (23)
Rocker Arm Lock Nuts 18 (24)
Rocker Arm Pivot Bolt 46 (62)
Shift Lever Torque Rod Bolt 16 (22)
Timing Belt Tension Adjuster Bolt 40 (54)
Torque Converter Drive Plate Bolts (5) 54 (73)
INCH Lbs. (N.m)Β 
Camshaft Bearing Bolt 84 (10)
Crankshaft Rear Seal Cover Bolts 96 (11)
Fuel Service Bolt 108 (12)
Oil Pan Bolts (5) 108 (12)
Oil Pump Screen Nuts 96 (11)
Timing Belt Cover Bolts 108 (12)
Valve Cover Nuts 84 (10)
Water Pump Bolt 108 (12)
(1) Tighten 6-mm bolts to 96 INCH lbs. (11 N.m). Tighten 8-mm bolts to 16 ft. lbs. (22 N.m). Bolts must be tightened in sequence shown. See Figure .
(2) Tighten connecting rod nuts in 2 stages. First tighten nuts to 14 ft. lbs. (20 N.m), and then tighten them to 23 ft. lbs. (32 N.m).
(3) Tighten cylinder head bolts in 2 stages. First tighten bolts to 22 ft. lbs. (30 N.m) and then to 61 ft. lbs. (83 N.m). See Figure .
(4) See Figure .
(5) Tighten in a crisscross pattern.
(6) Tighten to 96 INCH lbs. (11 N.m).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.