1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Engine Identification

Engine identification code is stamped on right rear of cylinder block as viewed from flywheel, below cylinder head mating surface. First 5 numbers of code indicate engine type. Last 7 numbers of code indicate engine serial number. Engine serial number starting from 1000001 indicates a California vehicle. Engine serial number starting from 1300001 indicates a Federal vehicle.

ENGINE IDENTIFICATION CODES

Application Engine Code
1.7L 4-Cylinder B17A1
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.