Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Radiator & Condenser Fan Relays
- Basic operation of relays used for A/C compressor and cooling fans is similar, although physical appearance of relays may be different. Remove relay to be tested. See Figure , Figure , or 4.
- Connect an ohmmeter to relay terminals "A" and "B". See Figure . Apply battery voltage between terminals "C" and "D". Continuity between terminals "A" and "B" should exist only when battery voltage is applied to terminals "C" and "D".
- If relay does not operate as specified, replace relay. If relay operates as specified, check related wiring. See TIMER UNIT & FAN CONTROL UNIT.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.