1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
ABS Inspection Connector Under passenger seat. See Figure .
Air Boost Valve (A/T) Rear of intake manifold. See Figure .
A/C Diode Below right side of dash, below evaporator housing.
A/C Thermostat Behind center console, on left side of evaporator.
Blower Motor Resistor Behind glove box, on top of blower motor housing.
Chime Module Behind center of dash.
Cooling Fan Timer Behind center of dash, on right side of heater assembly. See Figure .
Cruise Control Actuator On left side of engine compartment, in front of strut tower.
Diagnostic Connectors Behind right kick panel.
Emission Control Box On right side of firewall (includes EGR & fast idle solenoids). See Figure .
Fuel Injector Resistor In left rear corner of engine compartment.
Fuse/Relay Block
Engine Compartment On right side of engine compartment, behind strut tower. See Figure .
Passenger Compartment Behind left kick panel. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.