Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Mirror Switch Test
Remove power mirror switch. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals with switch in each position. If continuity is not as specified, replace switch. See Fig 1 . See POWER MIRROR SWITCH CONTINUITY TEST table.
| Application | Terminal Numbers | |
|---|---|---|
| Right Mirror | ||
| Off | 3-5-6-10 | |
| Up | 5-9 | |
| Down | 3-9 | |
| Left | 6-9 | |
| Right | 3-9 | |
| Left Mirror | ||
| Off | 4-5-7-10 | |
| Up | 5-9 | |
| Down | 4-9; 7-9 | |
| Left | 5-9; 7-9 | |
| Right | 4-9 | |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.