Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Legend (1992)
- Turn ignition off. Remove 2 screws from instrument cluster bezel. Pull out instrument cluster bezel far enough to disconnect 3 electrical connectors (one on left side and 2 on right side). Remove instrument cluster bezel.
- Ensure main switch is off. Using a DVOM, check for continuity between main switch terminals "A" and "B" and "D" and "E". See Fig 1 . Continuity should be present. If continuity is present, go to next step. If continuity is not present, replace malfunctioning main switch.
- Ensure main switch is on. Using a DVOM, check for continuity between main switch terminals "A" and "B", terminals "B" and "C", and terminals "D" and "E". See Fig 1 . Continuity should be present. If continuity is present, main switch is okay. If continuity is not present, replace malfunctioning main switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.