Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Cable Reel: Integra
- Remove steering wheel. When steering wheel is removed, SET/RESUME switch will be disconnected from cable reel. Remove steering column covers. Disconnect cable reel 3-pin connector from main harness.
- Using a DVOM, check for continuity between cable reel 3-pin connector (disconnected from main harness), Blue/Red wire and cable reel 3-pin connector (to SET/RESUME switch) terminal "D" while turning cable reel. See Fig 1 .
- Check for continuity between cable reel 3-pin connector Light Green/Red wire and cable reel 3-pin connector terminal "E" while turning cable reel. See Fig 1 . Continuity should be present. If continuity is present, cable reel is okay. If continuity is not present, replace cable reel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.