Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
BRAKELIGHT Switch: Integra
- Disconnect 4-pin connector from brakelight switch. Using a DVOM, check for continuity between brakelight switch terminals "A" and "B". See Figure . Continuity should be present. Check for continuity between brakelight switch terminals "C" and "D". Continuity should not be present.
- Depress brake pedal and hold. Check for continuity between brakelight switch terminals "C" and "D". Continuity should be present. Check for continuity between brakelight switch terminals "A" and "B". Continuity should not be present. If continuity readings are not as specified, check brake pedal height. See BRAKE PEDAL HEIGHT under ADJUSTMENTS . If brake pedal height is okay, replace brakelight switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.