Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Actuator Assembly
- Disconnect 4-pin connector at actuator. Actuator is located on left side of engine compartment. Using jumper wires, connect battery voltage to terminal "D" of actuator connector and terminal "A" of actuator connector to ground. See Fig 1 .
- Check for clicking sound from magnetic clutch and ensure output linkage is locked. If actuator output linkage is not locked, replace actuator. Check actuator motor operation in each output linkage position. See Fig 1 . If actuator motor operates as described in Fig 1 , actuator assembly is operating properly. If actuator motor does not operate as described in Fig 1 , replace actuator assembly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.