Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Disabling System
- To disable SRS, turn ignition off. On coupe models, wait at least 3 minutes to allow capacitor in back-up circuit to discharge, preventing a malfunction of seat belt pretensioner.NOTE: Before disconnecting battery cables, obtain radio anti-theft code number from customer, and deactivate radio anti-theft.
- On all models, disconnect battery cables. Remove maintenance lid below driver-side air bag. See Fig 1 Remove Red short connector. Disconnect 3-pin connector between air bag and cable reel. Connect Red short connector to air bag side of connector. On coupe models, connect SRS Short Connector "A" (07MAZ-SP00200) to cable reel side of connector. See Fig 2.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.