Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Ignition Coil Test (Legend)
- Turn ignition off. Remove ignition coil. Using an ohmmeter, check resistance between primary terminals "A" and "B" of ignition coil. See Fig 1 .
- Resistance should be .9-1.1 ohms at 77°F (25°C). Replace coil if resistance is not within specification. Resistance value for secondary winding is not available.IGNITION COIL RESISTANCE (LEGEND)
Application Ohms @ 77°F (25°C) Primary .9-1.1 Secondary N/A
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.