1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE

Master Switch

Remove power window master switch. See WINDOW SWITCH under REMOVAL & INSTALLATION. Check for continuity between specified switch terminals with switch in each position. If continuity is not as specified, replace switch. See Fig 1 . See POWER WINDOW MASTER SWITCH TEST table.

POWER WINDOW MASTER SWITCH TEST

Position Main Switch Pin Continuity
Driver's Switch
Off (1) "K"-"L"-"M"
Up (1) "K"-"N"
Down (1) "M"-"N"
Down (AUTO) (1) "M"-"N"
Right Front Switch
Off On "C"-"D"-"O"
Off Off "C"-"H"
Up On "C"-"H"
Up Off "C"-"H"
Down On "D"-"H"
Down Off "D"-"H"
Left Rear Switch
Off On "A"-"B"-"O"
Off Off "A"-"B"
Up On "A"-"G"
Up Off "A"-"G"
Down On "B"-"G"
Down Off "B"-"H"
Right Rear Switch
Off On "E"-"F-"O"
Off Off "E"-"F"
Up On "E"-"J"
Up Off "E"-"J"
Down On "F"-"J"
Down Off "F"-"J"
(1) Main switch position does not affect driver's switch operation.
Fig 1: Master Switch Terminal ID
G93A82545Courtesy of AMERICAN HONDA MOTOR CO., INC.
Chapter Navigation
Return to Chapter: Switch Test
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.