Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Acura Integra GS-RFACTORY OEM SERVICE PROCEDURE
Set/Resume Switch: Integra
- Remove steering wheel. Disconnect SET/RESUME switch 3-pin connector from cable reel. Using a DVOM, check for continuity between SET/RESUME switch 3-pin connector terminals "A" and "C" with SET pressed. See Fig 1 . Continuity should be present. If continuity is present, go to next step. If continuity is not present, replace SET/RESUME switch. See SET/RESUME SWITCH under REMOVAL & INSTALLATION .
- Using a DVOM, check for continuity between SET/RESUME switch 3-pin connector terminals "B" and "C" with RESUME pressed. Continuity should be present. If continuity is present, SET/RESUME switch is okay. If SET/RESUME switch is okay and cruise control system is malfunctioning, see CABLE REEL under DIAGNOSIS & TESTING . If continuity is not present, replace SET/RESUME switch. See SET/RESUME SWITCH under REMOVAL & INSTALLATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.