Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Map Sensor
Disconnect vacuum hose from MAP sensor. Connect a hand-held vacuum pump to MAP sensor. MAP sensor is located in Emission Control Box on right center of firewall. Apply vacuum to MAP sensor. See MAP SENSOR VOLTAGEΒ table. Backprobe ECU connector, and measure voltage between ECU terminal C11 (positive) and ground. Voltage reading should be as specified in MAP SENSOR VOLTAGEΒ table. Replace MAP sensor if vacuum is not held or voltage is not as specified.
| Vacuum Applied - In. Hg | Volts |
|---|---|
| 0 | 2.8-3.0 |
| 5 | 2.3-2.5 |
| 10 | 1.8-2.0 |
| 15 | 1.3-1.5 |
| 20 | .8-1.0 |
| 25 | .3-.5 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
