Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Scion iMOil Type & Capacity
OEM spec from the factory service manual for the Automatic CVT Trans variant.
Quick Answer
Oil Type
TOYOTA Genuine Motor Oil - ILSAC GF-5 Multigrade Engine Oil, SAE 0W-20
Capacity (w/ Filter)
4.40 QTS.
4.16 L
Variant
Automatic CVT Trans
Note: SAE 0W-20 is the best choice for good fuel economy and good starting in cold weather.
If SAE 0W-20 is not available, SAE 5W-20 may be used. However, it must be replaced with SAE 0W-20 at the next oil change.
The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick.
Source: Factory service manual — 2016 Scion iM Automatic CVT Trans. View full manual section →
What You'll Need
Frequently Asked Questions
- What type of oil does a 2016 Scion iM take?
- The 2016 Scion iM requires TOYOTA Genuine Motor Oil - ILSAC GF-5 Multigrade Engine Oil, SAE 0W-20. The exact spec may vary slightly by engine variant — this page shows the OEM recommendation for the Automatic CVT Trans configuration.
- How much oil does a 2016 Scion iM need?
- The 2016 Scion iM takes 4.40 QTS. (4.16 L) of engine oil with the filter replaced.
- Can I use synthetic oil in my 2016 Scion iM?
- Yes — synthetic oil that meets the TOYOTA Genuine Motor Oil - ILSAC GF-5 Multigrade Engine Oil, SAE 0W-20 specification is acceptable and often preferred for better protection and longer change intervals.
- What happens if I use the wrong oil in my 2016 Scion iM?
- Using oil that does not meet the TOYOTA Genuine Motor Oil - ILSAC GF-5 Multigrade Engine Oil, SAE 0W-20 specification can reduce engine protection, increase wear, and potentially void warranty coverage. Always use oil that meets the OEM spec.